When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So, all that being said.. say I wanted to run up to one of these shops and pick up lowering springs, which one of the local shops that you guys listed would have anything in stock, if at all.
^ its the only shop around here that built a high power z (well, cantrell built colin's, but they charge an arm and a leg and a half). it was an 05 i think, built motor, aps extreme kit, fcon, tuned by sam at gtm. made 6xx whp on low boost. the owner totaled it a month or 2 (maybe 3) after it was completed though, now they have the engine sitting in their shop...
imo, they're the most experienced vq shop locally...
You are not wrong about Cantrell being a bit on the pricey side but given that I have not had to take my car back there for anything engine related is a testimony to their work.
Pat, have you considered just putting all of your copypasta in your sig for easier access? bla bla ASE bla bla master bla bla offsets bla bla rotas suck dinosaur.
Would it be better to just make an actual thread and keep bumping it every so often like you?
his mouse broke. His computer is stuck on one thread, so the only way to accumulate post counts for him is to keep bumping the thread. I believe he found a mouse recently at garage sale LOL (J/k jining). Now he even posted a DIY install on a computer mouse. I believe a lot of Microsoft people will avail themselves of this DIY thread.
