Hello Guys,


I have searched high and low before posting this question on here.

How do I open the dome Light to change bulbs in our Z.


I do not want to break any tabs etc...


thanks

Mike

 

just pop a screwdriver in there and pop em out... that's all I did when I installed the LEDs.

 

thanks for the reply....I did the same with the liscense plate lights but for the dome lights i dont see any notch or gap to pop a screw driver in..it all looks hella flush.

thanks

Mike

 

A small flathead and pry out the lens from the inboard side. Refer to the owners manual if you need a better explanation, it details the task very well.

 

Information is located in Section LT of the FSM.

http://www.xenonz33.com/reference.html

 

Do very carefully, or you might slip, drop the flathead screwdriver and have it flip and land in your eye...Ouch!!! Mine, a jewelers fltp, slipped, flew and jabbed nose! ouch I did manage to install the dual 20 LEDs fixtures in place finally. The hard part was explaining the pokked nose. m

You thought I was kidding at 1st. Murphy'y Law here