My 2jz swap
The following users liked this post:
BluestreamDE (03-04-2018)
The following users liked this post:
BluestreamDE (03-12-2018)
#105
New Member
Thread Starter
The following users liked this post:
BluestreamDE (03-17-2018)
#109
New Member
Thread Starter
#110
New Member
Thread Starter
Took the car out a few times this last weekned trying to keep the boost down to wg spring only 14lbs ,the lowest i can keep it down to constantly is 20lbs so looks like my low boost will be 20lbs .
The following 2 users liked this post by chase z:
blax 350 (04-20-2018),
BluestreamDE (04-20-2018)
#114
New Member
Thread Starter
So went to the dyno today spent 7 hours there had a few wire or ecu gremlins that i have to track down but i did solve my over boosting/ not boost control. At 11psi base gate pressure it made 443hp . Maxed out my boost solenoid at 24 psi it made 638hp 519tq. Once the wiring gremlins are sorted i will go back and with a bigger base spring for the gate and turn it up. Still lots of power left on the table
Last edited by chase z; 04-21-2018 at 06:32 PM.
The following 2 users liked this post by chase z:
bealljk (04-21-2018),
BluestreamDE (04-21-2018)
#115
350Z-holic
iTrader: (13)
that's awesome congrats on the dyno & the numbers!
I'm happy to hear that I'm not the only one that has wiring issues on the dyno...
I'm happy to hear that I'm not the only one that has wiring issues on the dyno...
#116
New Member
Thread Starter
#117
350Z-holic
iTrader: (13)
you're going to push it to 40psi?
#119
350Z-holic
iTrader: (13)