We'd like to welcome R/T Tuning to the Uprev Pro Tuner list.

They aren't in NYC but are just a short drive away. They will be getting the system this weekend, so start making your appointments now.


R/T Tuning
635 W Third Street
Lansdale, PA 19446
(215) 855-5565
http://www.rttuning.com

 

UPREV is blowing up!!

 

Can't stop, won't stop.

 

Eh Eh, Eh Eh..

 

 

You read my mind.....

 

take dat... take dat

 

Nice to know..... Thanks for the heads up

 

def. nice to know but still very far.....

 

aka A Scenic drive through New Jersey.

 

They are not far from my house... it says 40min, 20 miles on mapquest... I plan on going to the shop to check it out and get some pricing. This seems like a way better alternative than getting a UTEC and doing it all myself, or finding a UTEC tuner on the east coast that is close enough to my house to go to if I need a slight tweak of a map.

 

uprev.... can't pm you so ill post here, if i get a vortech kit as a tuner kit, 3.12, possibly 2.87 pulley and a walbro 255 and some 550cc injectors, can you set me straight and about how much for the tune...im in upstate ny, ilion ny 13357, its about hour and half from albany.. so would this place be the closest to me... been debating picking up a used utec and getting it tuned or going with this new and upcoming great tuning i hear about..

 

+1 for R/T - these guys are top-noch.

 

Grand Opening Spring BBQ? Very close to central jersey. 1 hour, 33 minutes. Closer than some shops in souf jerzy

 

Not sure how much the tune will run you, thats charged per shop. $400 for Osiris Flash (not sure if you already bought Osiris or not).

Are you on a stock motor? Don't want to run too small of a pulley with the stock motor, it just won't take it.

 

im not concerned with the pulley sizes, thanks...im not lookin for a reflash either..probably go utec i guess

 

Not sure whats up with the hostility.

You've been asking about our product for a while now, we only do Reflash. Thats how you interface with the stock ECU. So not sure why you would ask us about our product and then say you don't want a reflash.

 

i ask for info. on your product and you give me somethin about pulley size and built block. . my setup is fine im fully aware of what pulley sizes are gonna be ok and what not...

i do not want a reflash where i mail in my ecu, i would be fine with a custom in house tune and a reflash that way which is why i asked but didn't get any info. so basically maybe ill stick with something i know and something i know will get the job done.. i am curious of this software but its just not in my area and i really can't get any usefull info. on it since nobody around here works with it.

 

didn't mean for hostility but i did not ask for that info. is all im saying...it is setup now with rev-up cog configuration with 2.87 pulley on a non-revup...i am gonna need a tune for this along with headers, test pipes, exhaust, plenum spacer etc. few more mods...now there are shops closer that tune utec's is what im saying and i really don't have valuable info. on your product or know anyone who has used it... and like i said def. not looking for a mail in reflash

 

I can vouch for R/T Tuning. Vince, Pat, Matt and Shawn will take care of you. They know their stuff.