Is the ecu pinout for 06 same as 03-05? is pin 62 still rpm signal on the 06?

 

http://www.innovatemotorsports.com/r...5_G35_350z.php

 

so i guess that includeds 06's?

 

From my reading yes

 

is their an easier way of getting rpm signal without going through the ecu?

 

What are you wanting it for?

 

i need my car to blow up at 4000 rpms lol jk window switch...

 

Window Switch ??

 

rpm window switch for nitrous...

 

Well then I would just go to the ECU then.. It's not that hard to get to

 

yea but those damn ecu cables are so skinny im scared of breaking them lol, thats why i wanted to see if their was another way...

 

Pin 62 has not changed between the 03-06 years. Also it is ignition output #1, and you could also get it at the ignition coil if you wanted.

 

Has anyone heard about putting a meter on that pin and setting it to hertz and able to tell you RPM's. I am looking a small shift light and their website says if you can do this, then that pin will work with their unit?

 

I was looking into that as well for my 35anni Z but I think 05 Revup and 06+ had a different ecu layout than the 02-04. It is no longer pin 62. I am having a hard time locating a tach signal for my VSD-X. Hopefully someone can chime in..

 

for the 06 rev up, pins are the same, wire colors are different. If you need the colors you can convert them using the 06 factory service manual.

 

i'm sure for a tach signal you need to use a coverter like the one used with the greddy emanage.