Notices
lystroi's Avatar
lystroi
Thread Starter

350Z Tech Area / Engine & Drivetrain    Today 02:30 PM

icer5160
What year is your Z? What engine/trans combo? Just to confirm, this noise only happens when you shutoff the engine, does it happen immediately after cutting the engine or is there a delay? My...
It’s a 2004 Enthusiast with a JATCO RE5R05A 5-speed transmission. Theres about a 3-10 second delay after cranking the car completely off.

0 Reply
kukanad's Avatar
kukanad
Thread Starter

My350Z.com / Feedback & Suggestions for Our Forum    Today 02:13 PM

For the past several months my 2005 350z has been losing the battery charge. I have a new alternator, new starter, and new battery. If it sits more than a day the battery is dead. 2 times that it's...

0 Reply

350Z Tech Area / Maintenance & Repair    Today 08:46 AM

icer5160
This post is very old and I doubt any of the previous users will respond. Having recently done this job, here's my recommendation... Your best bet is to remove the entire frame piece. It's held in...
Icer, Thank you so much for responding to a very old post. Literally, in searching the internet and Youtube, this is the only guide I can find, so I'm definitely lucky you were still paying...

0 Reply
eZg's Avatar
eZg

350Z Tech Area / Engine & Drivetrain    Today 05:40 AM

check your grounds too!!

0 Reply
Bolognahammer's Avatar
Bolognahammer
Thread Starter

350Z Tech Area / Engine & Drivetrain    Today 05:09 AM

Im running into an issue putting my engine back together after a rebuild. I have the aluminum valve covers from CZP and the kinetix velocity intake manifold. when taking everything apart I found...

0 Reply
zwei_the_c's Avatar
zwei_the_c
Thread Starter

2003-2009 Nissan 350Z / New Owners    Yesterday 11:30 PM

Update: Removed all the braces, exhaust, HFCs and driveshaft. https://cimg0.ibsrv.net/gimg/my350z.com-vbulletin/2000x1504/img_7178_62cb121cb0f ca70e43b7f24cafb13b3 3d5c447a6.jpeg Now I am...

0 Reply

350Z Tech Area / Engine & Drivetrain    Yesterday 08:25 PM

I know it's been a week, and you may never come back to the forums. But I thought I would ask an AI model I've been training on the 06 FSM. Here's the detailed output I got for troubleshooting DTC...

0 Reply

All times are GMT -8. The time now is 04:09 PM.