https://my350z.com/forum/intake-exha...e-intakes.html

 

Group Buy is a gooooooooo $449+$9.95 shipping get in on this nowwwwwwwww

 

https://my350z.com/forum/vendor-grou...time-only.html

 

Come on guys its a great deal

 

sign me up

 

By far one of my most hated installs, the "drilling a hole for the the lower tube clamp" is absolutely irritating I'm at the point of giving up, this is just ridiculous.

 

PM sent.. I can't get to my R&D/Service staff this evening, but would be happy to help with the install in the morning..

 

i did not even install those tube clamps as they did not work for the 350 setup. i just put some rubber hose around the hole in which the pipes go thru in the front to keep the vibration noise down.

 

Hi All - I've installed the Stillen Gen3 onto my HR engine but stupidly have 'lost' the Adel clamps (p-clips here in the UK). Can anybody tell me the correct size of these clips please? I've measured the pipe and I think they'll need to be 2.5 inch (64mm) - does this sound right ?

 

Yes, they are 2.5" Adel Clamps..

 

1. raz0rbladez909
2. pizzato16
3. kuhan
4. siberian57
5. klenkart
6. fastz33
7.
8.
9.
10.

if the price is right

 

Thanks Josh

 

I'd be happy to supply them.. but being in the UK.. obviously that wouldn't make sense. I'm sure you took enough of a hit getting the kit there!

 

hey josh any chance on a GB??

 

We went around on this before.. and while there was stated interest, it didn't turn into the numbers needed for us to ramp production and bring costs down.

Keep an eye out for specials if you're looking to save a couple bucks, we may have something in the future, but it hasn't been much lower than it is now for even our 1-day sales. It is currently at special pricing..

 

yes the gb was ultimate fail. but i still got mine

 

im down, let me know when they are on special.

 

Same, I honestly feel as though the lower tube mounting (drilling a hole was a HUGE PAIN IN THE ***) could have been better on these, but overall I'm happy.

 

i didn't hook none of that **** up. i just put some rubber house slice in half around the edges of the holes where the pipes run thru on both sides to hold it in place.

 

coughhhh bump on the GB

i was jus thinkin about intakes as i was surfin the forums and i ran into this BUMPPPP