I got a good deal on a nitrous kit. I have a digital AEM wideband for it and wondering where to mount it. I have searched alot and everyone says drivers side. I also have a GTM resonated test pipes going in and a stillen y pipe. Should I have 2 new bungs welded on to my test pipes..somehow connect the two sensors to my one gauge OR can I just mount the sensor where the stillen y pipe comes to one pipe or will that be to far down stream for a accurate reading? When its all said and done I am going to have it tuned and want it to read correctly. Thanks in advance and if this has been covered I am sorry I just could not find the answer I was looking for.

 

your AEM should only have 1 sensor. Add an additional bung before the resonator in either test pipe.

 

it only came with one. But I read on here that two is better so wanted another opinion. i will add a bung to the drivers side test pipe and be done with it. thanks 8

 

How are you planning to use 2 sensors with a single gauge?

 

Not a clue. That's why i asked. I read in a couple places to install two...but who has two separate wide bands in there car? Didn't know if maybe you could switch one gauge in between the two sensors or something like that.