I recently got a Z when I got it the car would turn on go into gear but wouldn’t move I thought it was the clutch but turns out one of my output shafts from the diff had slipped out so I put it back in and when went out for a test drive the car felt jerky and would flash slip when going 10 mph so I jacked up the rear put it in gear and notice that the same side where the output has slipped the wheel has a weird wobble so I took it to a tire shop where they told me the rim is bent and no good I swap my fronts to the rear to see if it’ll help it did but not much I disconnected the axel and I notice that the output shafts also has a wobble to it keep in mind the diff it self doesn’t make any weird noise but the output shafts do wobble so does this mean I have a bad diff? I research and haven’t found anything that could point me to the right direction