Is anyone running 295's on a 10.5 wheel on a G coupe or 350z? I am looking to go from a 9.5 to a 10.5 wheel (with aggressive offset) in the rear while maintaining the same tire. Will this rub?? Keep in mind that the car is lowered on JIC coilovers, has had the fenders rolled considerably, and has adjustable control arms. If anyone is running a similar setup, any input would be appreciated... -Giovanni

 

anyone??

 

What are your offsets?

It's all depends on width and offsets.

 

Im planning to go 19x9.5 +22 and 19x10.5 +22.

 

i'm wondering also

 

i think it is possible to run a 295 on a 10.5 width wheel...
i think member 'mrjdmz33' had 295's out back on his 10.5" sf challenge's.... i believe he is now running a 315 width in the rear though...

 

It's gonna rub, without a doubt... with a +22, a 275/35 BARELY clears the fenders in some cases, and doesn't in many others... so a 295 is out of the question... be prepared to roll those fenders!

 

It'll fit if you roll or cut your fenders. Not a chance if you don't.

 

The fenders have already been rolled considerably, I was just seeing if anyone is running this similar setup without any problems...

 

Jason at Performance runs a similar set up. His car is lower than most too.

 

I believe he is running 18's though..

 

again, totally depends on the tires.....some 275's are as big or nearly as big as other 295's

 

IM RUNNING A 315 YOU SHOULD HAVE NO PROBLEM ROLLING IN FENDERS IS A MUST -GOOD LUCK-

 

I just ordered my volk SF-Challenges in a 19x10.5 with a 275/35/19 toyo T1S tire. My car is lowered and I plan on having to roll it. I was going to go to a 285 or 295 but Figured that I would come in to some problems that's why I did what I did.

 

that is very true.. I'm using Yokohamas AVS Sport. After hearing about some people using 315's, I think i'm going to go ahead and go 10.5..

 

do you know the offset of your wheels?