royal_T wheres that video?

 

NP!!! Can I borrow your hood ornament?!?!

 

^niccceeeee

 

new drop..

 

i see what you did there...

 

anymore pics of the hood ornament?

 

hy peopleZ

finally i became my wheels yesterday...i put them on without tires (dont have yet) just to see how it looks...

Work Euroline XS2
19x9 +10
19x10 +10

i dont know why some guys here said that the wheels wont stick out enough? i think the wheels stick out very nice?!

What do you guys think?

now i will buy the bc-racing coils...slam them down and see with which tires i can go with...

thx for your feedbacks!
luca

 

They stick out nice is because you have them on a lift. Once you put tires on it and lower it they will sink in, a lot depending on how low you go. That's why you see a lot of guys put a hydraulic jack underneath the wheel and compress it to see how it sits.

But those wheels are nice, and I've never seen that type of style lift here before. Looks like a slammed friendly lift.

 

sure they will sink in a bit...i will see then how much spacers i have to put on

the most lift here in switzerland are like this..they are not very "slammed-cars" friendli...but it has everytime a solution

 

donleguano, u will be in for a mild roll even then i would consider not lowering too much...looks good none the less..keep up the good work

 

x2...heheh

 

haha!!

Here you go!





And the rear is sitting nice too!






A different one...

 

what do you guys think i have to go for:

springs or coilovers? i know springs that slam my car for ca. 5cm...the problem is, i think it will rub becaus i can not set the range of springs...?
how much should i lower it?
do you think i have to put on spacers?

sorry for those many questions

luca

 

You can look at RPF1 (18x9.5+15/10.5+15) owners for reference. The "flushness" is nearly identical (w/o spacers) just with an 18" wheel.

 

how can i make the calculation to see which fitment is quite identical to mine?

is that right like this if i make the comparison of my wheels with the varrstoen:

my work:
19x9 +10
19x10 +10

varrstoen:
19x9.5 +12
19x10.5 +12

so i can make the calculation like this:

work:
9" x 2.54cm = 22.86cm
228.6mm - 10mm = 218.6mm

Varrstoen:
9.5" x 2.54cm = 24.13cm
241.3mm - 12mm = 229.3mm

that means, if i want the same flushness like the varrstoen +12
i have to put 10mm spacers in front and rear right?

thx for your feedback!
luca

 

The 9.5+12/10.5+12 will stick out about 4mm farther than 9+10/10+10. 5mm spacers would be sufficient if that's what you're looking for.

 

35mm/38mm spacer and your good to go.
just a mild roll needed.

 

Do you have the extended or short version of the Rays Duralumin lugs?

Thanks,
Dan

 

 

You have any pics of the front from the side? Car looks good!