Someone needs to save this thread. It's turning into sh*t.

 

Only the lord knows that I'm doing the responsible thing right now, delay all my plans by months!

That Nismo decal is retarded!

 

That setup does not belong in this thread, not even remotely aggressive enough

 

I call for a removal!!!! lol

 

Seconded.


All in favor........

 

fuking sick!

 

In an attempt to save this page (and the thread) I'd like to post my 2 favorite fat & aggressive setups of all time:


resauto:

HRE 543
19x9 -16 255 30 Conti sport
19x11 -3 315 25 Conti sport


















Toby-22:

19x9.5 +12 275/30/19
19x10.5 +7 305/30/19

 

Nice tribute post

 

Isn't Scott's 350Z N/A and I believe he run a 305 or 315 square set-up! So 245 on the front...

 

Someone wants to trade my 9.5 rpf1 front for his front 10.5 rpf1 so I may be running 10.5 square

Only problem is I already have tires garaged (275/285) so I may sell the 275 and be 285 square. Hopefully it all works out and I get these 10.5 front.

 

Scott has ran 305 square. Mike is crazy, he runs 315 A6 square on 18x10.5 +15 RPF1

 

The 275's will work just fine on the 10.5 inch wheels. Just wear them out and go 285 later.

 

315's tuck just fine on 99% stock fenders...

 

285/35-18 front and rear, fronts are on 10.5 Enkei NT03 spaced to +20 and the rears are on 10.5 +15 RPF1

http://www.flickr.com/photos/61208532@N05/8162983913/http://www.flickr.com/photos/61208532@N05/8162983913/ by http://www.flickr.com/people/61208532@N05/, on Flickr

http://www.flickr.com/photos/61208532@N05/8162967030/http://www.flickr.com/photos/61208532@N05/8162967030/ by http://www.flickr.com/people/61208532@N05/
I have some wheels to sell, then i will have matching sets of 10.5's front and rear.

 

Nice n chunky

 

Could anyone tell me if everything will be fine with 285/35 on 18x10 +25s in fronts?

 

I think someone has ran a similar set-up but I don't recall the wheel width and offset.

Suspension clearance: Package 2 is 25 mm (1'') closer to suspension/brakes components. Make sure that you have enough room for that. If not, consider lower offset, narrower tires or using spacers.
Fenders clearance: Package 2 will stick out 35 mm (1.4'') farther. Make sure that you have enough room under the fender. If not, consider narrower tires or higher offset.
Wheelwell clearance: The same.
SPEEDOMETER: When speedometer reads 60mph (96.6km/h) actual speed will be 59.8mph (96.3km/h): 0.3% slower.

Edit: Check out post #4314. LOL!!!!

 

The thing is that in the 4314 setup, its got +20 offset compared to my +25 and its a 10.5 width wheel

 

OK... You're set-up will sit 5mm closer to the suspension.

 

Comparing my specs vs yours, will fit no problem at all. You will even be able to run less camber if you want.

I run 10.5 +20 up front with 285's.