20" Axis Se7en Mods
#1
Registered User
Thread Starter
Join Date: Sep 2002
Location: Canyon Lake, TX
Posts: 585
Likes: 0
Received 0 Likes
on
0 Posts
20" Axis Se7en Mods
Just wondering if anyone here that has these wheels in the 20 x 9 front and 20 x 10 rear had any fitment issues or if they just bolted right on with no probs.
Thanks.
Thanks.
#2
Registered User
iTrader: (9)
Hey there Jeffrey,
I have them on my base 350z. They bolted right on AFTER I removed the guide bolts from the rotors. I also picked up a pair of spacers for them and stuck them on the rear rather than the front. If you are running brembo's then you may want to consider some 15mm spacers. I purchased the entire set from Wheel Studio in Cali as a huge package for ~2700 bucks. I highly recommend the wheels! But you really shouldnt run into any problems with fitment, etc...
--justin
I have them on my base 350z. They bolted right on AFTER I removed the guide bolts from the rotors. I also picked up a pair of spacers for them and stuck them on the rear rather than the front. If you are running brembo's then you may want to consider some 15mm spacers. I purchased the entire set from Wheel Studio in Cali as a huge package for ~2700 bucks. I highly recommend the wheels! But you really shouldnt run into any problems with fitment, etc...
--justin
#4
Registered User
Thread Starter
Join Date: Sep 2002
Location: Canyon Lake, TX
Posts: 585
Likes: 0
Received 0 Likes
on
0 Posts
Hey, thanks for the response Juztin.
Did you need the spacers or was it to make the wheels stick out a little more just for appearence?
I may be ordering these this weekend and I just want to know if I need anything special or not.
Thanks.
Did you need the spacers or was it to make the wheels stick out a little more just for appearence?
I may be ordering these this weekend and I just want to know if I need anything special or not.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM