we charge $315 at 78.15 an hour...

but its something we do a few times...

 

OK, so the quote is not that far off in terms of time. They say about 5 hours, and you are saying about 4. For some reason I thought it was a much smaller job.

Oh well, anything to make the car look fabulous. Thanks for the reply Jason.

 

no problem...

it is a farily easy install...

Remove Wheel,
Remove Caliper,
Remove Rotor,
Tap out existing hub bolts (there is a notch in the dust shield that will let them come out easily)
Pull in new hub bolts, take a few washers and put them under a lug nut and tighten it down until it is firm...
Replace Rotor,
Replace Caliper
Torque down lug nuts on wheel.

After 100 miles torque them down again...

 

why aren't these listed on the performance nissan site anymore? was there a problem/defect with them?

 

I have 19" rims w/ +31 in front and +37 in the rear. What size spacers do I need? How much will it cost?

 

i thought about this mod...but then when you figure in the labor for install you could put that towards new rims...unless you have a way to do it yourself