yeah man, it's scary. but once you start digging into your Z your gain some confidence. I didn't too anything too crazy so I'm fine with that.

 

Swapped out my front brake pads

 

Out with the old brakes and in with the new.
I think I'll wash and wax it too then take it for a nice drive.

 

New tires.

 

I started it, fired right up. It's been run twice over the past year, gas smelled pretty bad, I need to pull it out and drive it.

 

Changed the oil and clutch/brake reservoir fluid.

 

Terra, don't use any fuel-stabil??

 

Burn it all out until almost empty, then fill up with the good stuff and maybe add some SeaFoam.

I haven't seen my Z in a week.

 

Installed front bumper

 

New viper alarm getting installed. . Old viper 5900 burnt out after 7 yrs.

 

Hmm


Test fitted these.. Not convinced

 

Off to the machine shop...

 

Been sitting in the garage for over month. Was out of the country for a while, temperatures dropped really low. Probably gonna have some hellacious flat spots. Hope the new r compound tires didnt get f'ed up.

 

Threw on an eBay catback fitment was alright, the hangers were the problem, such a pita to get em off, fitment was same problem everyone says, one tip is about 1/2" off center, really a big improvement regardless with all my intake side mods, definitely a lot louder, louder than I expected but I'm content with it, however didn't get the invidia tp's on, will do that soon though. Cheers to another mod well done

 

You shouldn't have any flat spots, I have three cars and my z will at times not move for up to 3 months.

 

Need to get a moving permit , get it smogged , then will drive the tank out before I hit the track next month.

Looked at the Kognition wing mounting, going to be fun.

My air compresser died, need a new one to cut out the trunk for the wing

 

New rear tires put on after 15kish on the last pair. More milestars ms932 sport.

 

Drove my Z for the first time since Saturday, cleaned my driver-side floor mat afterwards

I also removed my NISMO b-pillar covers in order to wetsand/reclear them. They were yellowing after 6 years or use and will post my results afterwards once done

 

Very sh!tty rain day here.. getting things cleaned up for the (soon to be) built block

 

The angry bird under the bumper doesn't like them. I can tell.

I changed the wastegate springs on my greddy TT kit with the gates Installed on the car. To anyone wondering: yes it can be done. No you should not do it this way. Lol.