What did your z get for christmas
#5
New Member
iTrader: (3)
Z Tube and huge intake cone filter from Z1, new(used) HU, aluminum undershroud from ZSpeed. All last month so she would be dressed up for Christmas. and took her for a spirited drive yesterday since it was 40 degrees and the sun was shining. Might be more - have not had Christmas with the fam yet, waiting on the oldest to get back in town later today.
Trending Topics
#8
Didn't Go Cheap
iTrader: (25)
IPP Custom Stage 3 Long Block:
~~ Cosworth Rods, Cosworth 8.8:1 Pistons w/ Ceramic/Moly coating on the piston tops & skirts
~~ ACL Trust Washers, Main & Rod Bearings
~~ ARP Main Studs & Rod Bolts, L19 Head Studs
~~ ATI Street Damper Crank Pulley
~~ Heads Redecked, Ported Intake/Exhaust Runners, 5-Angle Radius Cut Valve Job
~~ JWT C2 {261* w/ .456 (11.58mm) lift Intake & Exhaust} Cams
~~ JWT Heavy Duty Springs & Shims
~~ Viton Valve Seals
~~ OEM Gasket kit with VQ35HR Head gaskets
~~ OEM VQ35 "Rev-Up" Oil Pump
~~ OEM VQ35 Pathfinder Rear Cooling By-Pass
~~ Nismo Low Temp Thermostat
~~ SPL Solid Diff Bushings
~~ Z Speed Performance Aluminum Undershroud
~~ Cosworth Rods, Cosworth 8.8:1 Pistons w/ Ceramic/Moly coating on the piston tops & skirts
~~ ACL Trust Washers, Main & Rod Bearings
~~ ARP Main Studs & Rod Bolts, L19 Head Studs
~~ ATI Street Damper Crank Pulley
~~ Heads Redecked, Ported Intake/Exhaust Runners, 5-Angle Radius Cut Valve Job
~~ JWT C2 {261* w/ .456 (11.58mm) lift Intake & Exhaust} Cams
~~ JWT Heavy Duty Springs & Shims
~~ Viton Valve Seals
~~ OEM Gasket kit with VQ35HR Head gaskets
~~ OEM VQ35 "Rev-Up" Oil Pump
~~ OEM VQ35 Pathfinder Rear Cooling By-Pass
~~ Nismo Low Temp Thermostat
~~ SPL Solid Diff Bushings
~~ Z Speed Performance Aluminum Undershroud
#10
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Z1 intake pipe and a couple of Z1 hoses.
#14
UR pulley kit, ebay test pipes (non-res), mishimoto thermostat, Energy suspension full front bushing kit (which turned out to be a fail), new oem tranny oil pan gasket, radiator flush, engine bay cleaned up, hatch repainted after removing nismo v2 wing.
Last edited by silvertouringz; 12-25-2011 at 10:27 AM.