mgntwo

Hey guys jusu put in new components and now my power window, power locks and the light in my driver door cup holder is out. Im thinking is the harness that i ran the new speaker wires through. Anyone know before i rip everything back off

jdohman

iTrader: (1)

Plug back in the clips that you unplugged when you took the door panel off. If it is only on passenger side still make sure the driver side is plugged in.

mgntwo

what clips, the wiring harness that plugs into the switchboard? cuz thats plugged in. im thinking its the one in the door jam with the big *** connector

EGP

Also check your fuses..

mgntwo

these fuses in the engine or down by the kick panal?

playa6tnine

iTrader: (5)

both

mgntwo

thanks guys for the responses.. just trying to make this quick and easy and not taking the whole interior out again

mgntwo

I Tried Putting The Harness Back Together And Still Nothing. When I Had The Lever Half Up The Windows And Locks Workded But I Soon As It Went Back To The Top They Died Again. Iim Assuming Obviously Has To Do With The Harness Not Connecting Anyone Have Any Tips Or Ideas?

16psibrick

iTrader: (10)

did you check to see if you have bent/missing pins in the molex harness plug int he door where oyu passed wires through? damanged pins or cut wire will result in this...

b

KPierson

iTrader: (1)

Did you run new wires for the components or use the existing?

If you ran new wires to the door I would start looking there.

playa6tnine

iTrader: (5)

does anone know how to put the grey lever back up after installation? i can only seem to get the harness in without the grey lever >:-(

350zspl

iTrader: (3)

when door panel was removed

and window and door lock plugs were un plugged


did you replug them back