DIY Rear View Camera Install
#81
SlammednFlush
iTrader: (6)
Join Date: May 2005
Location: The Market
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
I have a Kenwood DNX7100 and purchased the Moonet Rear Camera (Picture 1).
http://www.amazon.com/gp/product/B00...F5BK8CFPARE3KJ
My question are:
1. Tap the the RED wire (from the BLACK/RED power cable in Picture 1 to the right) to power the camera to the Light Green wire (reverse light in Picture 2)?
2. Where can I tap the BLACK wire for ground (from the BLACK/RED power cable in Picture 1 to the right)?
3. Do I need to tap the the RED wires on the VIDEO yellow wire (from the Video yellow cable in Picture 1 to the left) to the Light Green wire (reverse light in Picture 2) also?
Picture 1 (Moonet Rear Camera)
Picture 2 (Light Green Wire with Spots)
http://www.amazon.com/gp/product/B00...F5BK8CFPARE3KJ
My question are:
1. Tap the the RED wire (from the BLACK/RED power cable in Picture 1 to the right) to power the camera to the Light Green wire (reverse light in Picture 2)?
2. Where can I tap the BLACK wire for ground (from the BLACK/RED power cable in Picture 1 to the right)?
3. Do I need to tap the the RED wires on the VIDEO yellow wire (from the Video yellow cable in Picture 1 to the left) to the Light Green wire (reverse light in Picture 2) also?
Picture 1 (Moonet Rear Camera)
Picture 2 (Light Green Wire with Spots)
Red wire on the yellow video wire gets spliced to the reverse signal wire on your radio, should be a separate wire on the radio harness, it's how your radio knows you're in reverse and shows the camera. The other end of the red wire also gets connected to the reverse lights just like the power wire so it can send that reverse signal to the radio.
Thread
Thread Starter
Forum
Replies
Last Post
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM