HELP! Which directions slotted/drilled rotors go on? (PICS)
#43
Registered User
iTrader: (4)
Join Date: Apr 2005
Location: Biloxi, MS
Posts: 722
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by maximumsportZ
Guys thanks a lot, you guys are the best.
Thanks to doug, Erik, Jason, Andy for putting up with me.
Now its time to finish this!
Thanks to doug, Erik, Jason, Andy for putting up with me.
Now its time to finish this!
#45
Registered User
Thread Starter
iTrader: (25)
Join Date: Oct 2003
Location: Orlando, FL
Posts: 2,864
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Jason@Performance
what bbk is it anyway?
Well I'll finish it up tomorrow.. here she stands... excuse the mess.
Wilwood fronts and rear:
#47
Registered User
iTrader: (6)
Join Date: May 2005
Location: King of Materbation
Posts: 3,682
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by maximumsportZ
Wilwood's custom kit by Fastbreaks.
Well I'll finish it up tomorrow.. here she stands... excuse the mess.
Wilwood fronts and rear:
Well I'll finish it up tomorrow.. here she stands... excuse the mess.
Wilwood fronts and rear:
You guys made this the most complicated thread in 350z history
#48
Registered User
Thread Starter
iTrader: (25)
Join Date: Oct 2003
Location: Orlando, FL
Posts: 2,864
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by EM-EFER
Dont you dare installing them right now!Take back off the Rotors ,Calipers and wire brush that Rust underneath, then paint them BLACK!!
You guys made this the most complicated thread in 350z history
You guys made this the most complicated thread in 350z history
#52
Registered User
Thread Starter
iTrader: (25)
Join Date: Oct 2003
Location: Orlando, FL
Posts: 2,864
Likes: 0
Received 0 Likes
on
0 Posts
Done.
Took it around the block feels great, the pedal is a lot stiffer. Going to take it out tonight to bed the pads.
Everything went smooth, bleeding was pretty easy than a lot of ppl make it out to be.
Took it around the block feels great, the pedal is a lot stiffer. Going to take it out tonight to bed the pads.
Everything went smooth, bleeding was pretty easy than a lot of ppl make it out to be.
#54
Registered User
iTrader: (3)
Join Date: Jun 2005
Location: Columbia, MD
Posts: 2,040
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by J Ritt
This is one of the best posts I've seen in some time. After we're all done here, can we all congregate in the middle of the room and run around bumping into eachother? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
10-29-2020 07:44 PM
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM