Notices
Brakes & Suspension 350Z stoppers, coils, shocks/dampers
View Poll Results: Which swaybar do you use if it makes clunking/popping/knocking noises
Hotchkis
51
37.23%
Cusco
6
4.38%
Stillen
13
9.49%
Eibach
1
0.73%
350evo
0
0%
No noise
66
48.18%
Voters: 137. You may not vote on this poll

Does your aftermarket swaybar make clunking/popping/knocking noises?

Thread Tools
 
Search this Thread
 
Old Feb 8, 2007 | 12:35 AM
  #1  
Cloud's Avatar
Cloud
Thread Starter
Registered User
iTrader: (4)
 
Joined: Dec 2005
Posts: 409
Likes: 0
From: san diego/Rowland Heights
Default Does your aftermarket swaybar make clunking/popping/knocking noises?

If so which swaybar are you using?
Reply
Old Feb 8, 2007 | 12:37 AM
  #2  
Cloud's Avatar
Cloud
Thread Starter
Registered User
iTrader: (4)
 
Joined: Dec 2005
Posts: 409
Likes: 0
From: san diego/Rowland Heights
Default

Doing this to find out if hotchkis are the only swaybars that have the problem
Reply
Old Feb 8, 2007 | 05:49 AM
  #3  
nkohler's Avatar
nkohler
New Member
iTrader: (16)
 
Joined: Oct 2004
Posts: 565
Likes: 5
From: Columbia, MO
Default

cusco, no noise
Reply
Old Feb 8, 2007 | 06:35 AM
  #4  
Fluid1's Avatar
Fluid1
Registered User
iTrader: (19)
 
Joined: May 2005
Posts: 11,953
Likes: 0
From: NOPE NOPE NOPE
Default

Originally Posted by nkohler
cusco, no noise

+1

your poll doesn't make sense tho...people are going to vote for what they have on their car.
Reply
Old Feb 8, 2007 | 06:39 AM
  #5  
IIQuickSilverII's Avatar
IIQuickSilverII
New Member
iTrader: (13)
 
Joined: Oct 2005
Posts: 14,613
Likes: 215
From: Arizona -InP-
Default

yeap its confusing.......
Reply
Old Feb 8, 2007 | 07:25 AM
  #6  
RudeG_v2.0's Avatar
RudeG_v2.0
でたらめ検出器
Premier Member
iTrader: (1)
 
Joined: Feb 2007
Posts: 5,800
Likes: 2
From: Phoenix, AZ
Default

Originally Posted by Cloud
If so which swaybar are you using?
I have Cusco on my '06 and I had Stillen on my '04. I never had any problems with my Stillen bars, which were installed by the dealership. But I had those noises start shortly after I had my Cusco bars installed by a local speed shop. So I had my dealership check it out during my next service interval. It turned out that the speed shop that installed the sway bars did not torque the bolts/nuts to spec, so they became loose.

My dealership tightened them back up to spec and I have had no noise or problems with my Cusco sways since... and that was about 10,000 miles ago.

Needless to say, I will not be going back to this speed shop ever again, since they can't even do something as simple as putting on a set of sway bars correctly.
Reply
Old Feb 8, 2007 | 07:46 AM
  #7  
BamBam's Avatar
BamBam
Registered User
iTrader: (4)
 
Joined: Mar 2005
Posts: 2,880
Likes: 3
From: EveryWhere & yet... NoWhere
Default

I have hotchkis and no noises... But I have the ATS clutch and open dumps... Maybe I just don't hear it making noise.
Reply
Old Feb 22, 2007 | 09:54 AM
  #8  
Sunset350ZR's Avatar
Sunset350ZR
New Member
iTrader: (6)
 
Joined: Apr 2006
Posts: 829
Likes: 1
From: Knoxville, TN
Default

What is spec tightness?
Reply
Old Feb 22, 2007 | 12:50 PM
  #9  
MarkM's Avatar
MarkM
Registered User
iTrader: (1)
 
Joined: Jun 2004
Posts: 477
Likes: 0
From: Far enough away!
Default

I bought Nismo as quite a few members in here had complained about Hotchkis noise. Nismo s are fine!
Reply
Old Feb 22, 2007 | 02:57 PM
  #10  
DavesZ#3's Avatar
DavesZ#3
350Z-holic
Premier Member
20 Year Member
iTrader: (26)
 
Joined: Jul 2003
Posts: 15,887
Likes: 23
From: Louisiana
Default

It also isn't a very valid poll because you're not finding out how many are out there. If there are 10,000 Hotchkis and 100 Cuscos in use, and 100 Hotchkis and 5 Cusco users report problems, which one is better? The Cusco because only 5 people had problems? Or the Hotchkis because of the lower percentage (1% vs 5%) of problems.
Reply
Old Feb 22, 2007 | 04:59 PM
  #11  
VIZAGE's Avatar
VIZAGE
Registered User
iTrader: (20)
 
Joined: Oct 2006
Posts: 1,832
Likes: 1
From: South Atlanta
Default

Hotchkis: No probs.
Reply
Old Feb 22, 2007 | 05:05 PM
  #12  
ohSIXz's Avatar
ohSIXz
Registered User
 
Joined: Jan 2006
Posts: 1,224
Likes: 1
From: arizona
Default

i dont have em on my Z. but i had suspension techniques sways on my 98 civic, and they made noise at times.... turns out i pinched the bushings off my endlinks. just had to get some new bushings... that would probably be yer problem since everyone else has replied with no sounds. and its probably on the front too... i never had a problem with the bushings on the rear.... wait yes i did. never mind ;x
Reply
Old Feb 22, 2007 | 05:08 PM
  #13  
failsafe's Avatar
failsafe
....for your health
Premier Member
 
Joined: Mar 2003
Posts: 5,592
Likes: 1
From: Raider Nation
Default

Cusco, no noises.
Reply
Old Feb 22, 2007 | 05:11 PM
  #14  
Jay'Z's Avatar
Jay'Z
Banned
iTrader: (118)
 
Joined: Apr 2005
Posts: 10,944
Likes: 1
From: Carbon Fiber, TX
Default

I have hotchkis and no, no noises........ I have so much clacking and popping from my Nismo Lsd and Clutch/ flywheel combo.. I prob wouldnt know anyways.. Lol.. It wouldnt bother me..
Reply
Old Feb 23, 2007 | 06:48 AM
  #15  
Lawn Dart's Avatar
Lawn Dart
Registered User
iTrader: (4)
 
Joined: Jan 2004
Posts: 992
Likes: 2
From: New Castle, DE
Default

I had a clunking noise with Cusco stabilizers, however I had a major accident before I had a chance to see if it was the culprit or not. Since my front and rear subframe and lots of suspension pieces were replaced, I haven't had the problem anymore.
Reply
Old Feb 23, 2007 | 08:42 AM
  #16  
UltraYellow350z's Avatar
UltraYellow350z
Registered User
iTrader: (6)
 
Joined: Jun 2006
Posts: 161
Likes: 0
From: Atlanta, GA
Default

hotchkis no noise
Reply
Old Feb 23, 2007 | 08:43 AM
  #17  
SpoilsofWar's Avatar
SpoilsofWar
Registered User
iTrader: (39)
 
Joined: Jul 2006
Posts: 2,359
Likes: 1
From: Way North, New York
Default

Where is the button for the Progress bars?

Not that mine make any noise though
Reply
Old Feb 23, 2007 | 09:43 AM
  #18  
abui01's Avatar
abui01
New Member
iTrader: (68)
 
Joined: Oct 2005
Posts: 4,120
Likes: 1
From: McDonalds - NOVA - DC/MD/VA
Default

I've had both Hotchkis + Cuscos with no noise... grease those bushings!!!
Reply
Old Feb 23, 2007 | 04:59 PM
  #19  
myG35zx's Avatar
myG35zx
Registered User
iTrader: (2)
 
Joined: Feb 2003
Posts: 904
Likes: 0
From: Midwest
Default

I know I have said this several times already, but check the brackets that secure it to the frame. Even though they may look secure, I have found that they can be tweaked a bit that then causes "clunks" when driving.
Reply
Old Feb 24, 2007 | 06:59 PM
  #20  
Tekwon-V's Avatar
Tekwon-V
Registered User
iTrader: (13)
 
Joined: Mar 2004
Posts: 469
Likes: 0
From: House
Default

hotchkis setup (medium front & rear) and clunking. mostly when i go down an incline at an angle; one wheel touching the flat pavement first.
Reply



All times are GMT -8. The time now is 10:00 PM.