Lowering Springs Picture Thread
#401
New Member
iTrader: (1)
Thanks Trav,
Do you have any pics with either of those coils on a 40 profile tire? I am good with a 1-2 finger gap if that is the case. What did you end up switching out for? tanabe GF120s? those were my second choice but I saw some pictures and the front of the 40 profile tire seemed like it tucked just a hair under the front fender (which is too low for me).
Thanks!
T
Do you have any pics with either of those coils on a 40 profile tire? I am good with a 1-2 finger gap if that is the case. What did you end up switching out for? tanabe GF120s? those were my second choice but I saw some pictures and the front of the 40 profile tire seemed like it tucked just a hair under the front fender (which is too low for me).
Thanks!
T
#403
New Member
iTrader: (1)
In this picture, do you recall the spring set-up? also are these the 40 series profile tires?
Also with this drop, I was planning to do upper control arms (Kinetix), however since its roughly 1 inch drop I was also thinking just ugprade the OEM upper control arm bushings to whiteline perhaps (instead of buying whole new Kinetix UCA). What is your input between the 2 at this height (ideal height is the picture below).
thanks!
Last edited by Bak3rme; 07-22-2018 at 07:50 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM