Once I start to from a stop then to a roll I hear a noise like a click here and there. What could this be? After the roll I dont hear it again.

 

It's a bent crankshaft.


















Seriously, does the frequency increase with speed? Does it go away after a bit? Have you done any work on it recently.

 

axle click probably , or you have a rock in a tire.

 

It could be that you are not using search?

 

Please use the site search for the terms "axle click".

This issue has been covered extensively.

 

Is this something i should fix asap or can it wait?

 

wait like till sumin falls off

 

It is my driveshaft by the way sorry for not searching 1st.

 

I am new to these cars so any information will help...

 

https://my350z.com/forum/maintenance...-warranty.html

I typed "axle click" into the search and was given the above.

 

You have to either replace the outer cv joint(s) and bearing(s) or do what I did. I am the warranty on my Z. Take the wheel off and loosen the axle nut almost all the way. Tap gently with a hammer, the axle will slide in about 1-1+1/2 inches. Get some spray copper anti-seize with a straw and very carefully spray it into the splines from both sides. Get a fair amount of it in there but don't make a mess. Then just torque the nut to about 180ft/lbs and the click is gone. I just did this a week ago so I'm not sure how long it will last, but it worked. I put the anti-seize on my squeaky clutch fork pivot ball over 2000 miles ago and it's still silky smooth, it's good stuff, but I did tell you the right way to do it. The clicking cv and bearing should never be a problem anyway, just annoying.