Anybody with M/T ET Streets, Running them WITHOUT or WITH Tubes and Rim Screws?

What Air Pressure are you running at?

Thanks,

TimRod

 

I know there are a few guys out there using ET Streets.....

Can you jump in.......

 

I have M/T ET Streets and I run them without the tubes and without the screws.

As for the pressure, I start at around 17 psi and adjust based on my runs.

 

Whats the lowest air pressure you have used?

How well do they hold air?

Did you glue the Bead?

Thanks
TimRod

 

Generally speaking if you keep them above 12 w/a little extra bead seal they will hold w/o screws. If you plan to go 12 or lower....get them screwed. Tubes aren't necessary.

 

Same here. I keep mine at 16psi.

 

I think the lowest I've gone on these was 15.

One loses air a bit faster than the other one but over time. For a one day drag strip use, they hold air just fine and I don't have to pump them back up (unless I let out too much).

They were mounted normally at Discount Tire.

 

Thanks Guys,

Micky Thompson said that Tubes are Required with ET Streets, and if you install Tubes, then Rim Screws are Required........

Thanks Again, I thought I say guys runniing Without.......

TimRod