k6750gsxr

iTrader: (17)

PERSONAL BEST... only two runs...12.3 and this one.

04 TOURING 5AT
GTM TT 30R'S
NT05R RADIALS
9 PSI RUN.
11.94



http://www.youtube.com/watch?v=Y4M9eWQmXFc

Nexx

iTrader: (41)

good schit, work on that 60 ft and low 11's isnt far off

eltness350

iTrader: (58)

^^+1 nice job!

ehsan

iTrader: (12)

Kinda makes me wish i went with you last night..

Alberto

iTrader: (14)

How much power?

11's is very respectable in only a few runs.

k6750gsxr

iTrader: (17)

9.4 what the peak boost on logger. Some where in the 450 area I would imagine going by the mph. That was my 5th pull with this set up. Only made 2 pulls last night because the track guy told me I needed a helmet.



Thanks for all the positive feedback guys. This has been a long journey. I have been screwed by a shop a lot and did this my self. So I am content.


For the life of me I can't get it to launch harder. That's why my 60ft was on the high side.

Alberto

iTrader: (14)

Sometimes, going "easier" off the line will result in faster 60ft's.

Is your tire pressure down to 16-18psi? Are you properly heating them up? Radials shouldnt be run higher at the track.

With a 1.7 thats an easy 11.70 pass....

k6750gsxr

iTrader: (17)

Tires were 18 psi... hooked very well. Heat cycle them every time. I launch with the stall up to pre load the trans. Never cones out the hole hard because the highest I can pre load it is to 2900rpm before it starts to creep forward.. Not enough for the turbo to spin up.

rcdash

iTrader: (18)

Nice run! Do you have pin 101 of the ECU disabled so you can do a brake torque launch effectively without the ECU closing the throttle? I can get to maybe 1 psi with a spark cut brake torque launch at 2500 rpms (twin GT28s). I can on the fly reroute the brake signal (pin 101) to the aux rev limiter of the Haltech to give me a 2 step.

ajcool2

iTrader: (11)

At first I thought your RT was your 60' haha. Nice job reppin the 5at's. Everybody breaking 11's but me.

k6750gsxr

iTrader: (17)

I pulled the break fuse. Figured that's all I needed to do. Isn't the 101 pun the same thing its just easier if you want to do it on the fly ?

k6750gsxr

iTrader: (17)

Actually on the 11.9 run I didn't have the fuse removed. I was still able to do a good heat up on the tires. I thought with it not removed you couldn't do a burn out.


Plus I have osiris on my ecu which allows me to keep it open ?


Rcdash what is your best run ?

ajcool2

iTrader: (11)

Not quite. Ive had times where I my rpm would rise real slow with my brake fuse pulled and I would let off the brake pedal just a little and the rpms would jump up. So it still cuts power a little.

ajcool2

iTrader: (11)

I would assume you are making enough power to spin the tires even with the fuse in. I can do weak burnouts with my fuse in.

NissanZ03

iTrader: (12)

Good stuff man

ImWeeZzel

iTrader: (27)

could you post pics of your car please? Id like to see this bad boy.
k thanx

ehsan

iTrader: (12)

here:

kacz07

iTrader: (15)

^Oh wow, oh...

ehsan

iTrader: (12)

A buddy of ours owns a vinyl business so we help promote his work. New and different design coming soon for his car

k6750gsxr

iTrader: (17)

here are some pics .....