Swapped non revup not running
Thread Starter
New Member
Joined: Mar 2021
Posts: 3
Likes: 0
From: Tennessee
Swapped non revup not running
I just recently built my non revup vq35de the list includes:
Wiesco pistons 11:1 compression
Manley H-beam rods
L-19 APR head studs
APR main studs
new oil pump with boundry billet gear
All new bearings main and rod
Comsic head gaskets
All new oem gaskets
Block has been decked and bored(stock bore still)
everything balanced
JWT light weight flywheel and new OEM clutch
Anyways. motor was swapped and does not run right. It will start and crank over really rough. Will idle for about 30 secs, can't rev past 1k and dies. It was getting oil pressure and now is not getting any according to the guage. I changed the spark plugs and they were soaked in fuel and were black. So I think its compensating and adding more fuel making it run rich. Any ideas? My last idea is it could be the flywheel aligned wrong.
Wiesco pistons 11:1 compression
Manley H-beam rods
L-19 APR head studs
APR main studs
new oil pump with boundry billet gear
All new bearings main and rod
Comsic head gaskets
All new oem gaskets
Block has been decked and bored(stock bore still)
everything balanced
JWT light weight flywheel and new OEM clutch
Anyways. motor was swapped and does not run right. It will start and crank over really rough. Will idle for about 30 secs, can't rev past 1k and dies. It was getting oil pressure and now is not getting any according to the guage. I changed the spark plugs and they were soaked in fuel and were black. So I think its compensating and adding more fuel making it run rich. Any ideas? My last idea is it could be the flywheel aligned wrong.
Thread
Thread Starter
Forum
Replies
Last Post