FS: SOLD! BC 88mm stroker more than 12k invested SOLD!
SOLD! BC 88mm stroker more than 12k invested SOLD!
Specs are BC 88mm crank, BC rods 96.5 JE 11.0.1 pistons Ported and polished head 5 angle valve job on +1mm Manley valves and Jim Wolf S7 cams.
All ARP fasteners, Forged girdle, ARK knockoff large oil pan
I have over 12k in this a stock low mile motor commands 3k. Looking for 5k plus actual shipping.
No front cam solenoid
Cylinder 2 was viewed through a scope and appears to have lost a piece of the top. The crank is ok, the rod is ok.
I will have a picture from the scope later.
All ARP fasteners, Forged girdle, ARK knockoff large oil pan
I have over 12k in this a stock low mile motor commands 3k. Looking for 5k plus actual shipping.
No front cam solenoid
Cylinder 2 was viewed through a scope and appears to have lost a piece of the top. The crank is ok, the rod is ok.
I will have a picture from the scope later.
Last edited by e30cabrio; Jun 11, 2013 at 05:09 PM.
Reacp (I am sure I am forgetting alot)
BC discontinued 88mm crank, Forged girdle, BC rods, JE 96.5mm pistons, bored clearanced block all new timing chains, guides, tensioners. New Revup oil pump, water pump thermostat (don't remember which but higher performance) front & rear seals & gaskets etc. No expense was spared. To avoid being where I am now.
Reasonable offers/part out requests considered.
BC discontinued 88mm crank, Forged girdle, BC rods, JE 96.5mm pistons, bored clearanced block all new timing chains, guides, tensioners. New Revup oil pump, water pump thermostat (don't remember which but higher performance) front & rear seals & gaskets etc. No expense was spared. To avoid being where I am now.
Reasonable offers/part out requests considered.
Trending Topics
I put three motors in the car. Motor 2 was a nightmare to get built and then a piston failed. It is all in this thread scroll up.
I want the motor, stand and hoist out of my garage and will consider any reasonable offer. Local is preferred as I have had headaches with unreasonable people expecting new condition for used parts priced reasonably.
If you are interested come see it and make me a reasonable offer.
I want the motor, stand and hoist out of my garage and will consider any reasonable offer. Local is preferred as I have had headaches with unreasonable people expecting new condition for used parts priced reasonably.
If you are interested come see it and make me a reasonable offer.
