if you notice there is a green X this is the height adjustment... but...
what is the adjustment before it under the cap?

 

Links don't work.

 

is there suppose to be something after image where the three ... are.

 

fixed

 

That represents a Philips head type adjuster for the headlight height adjustment. If you have a long #2 philips screwdriver, it will fit right into that opening and act as a driving gear for the teeth on that adjustment.

Those images came from Hypersprite's site. Here are his instructions for adjusting your headlight height....

http://www.hypersprite.com/auto/tech-z-003/index.asp

 

I know what the green arrow one is for... but what is the adjust went under the cap for?

 

I think your talking about the same thing, those teeth or triangle medal pieces are the adjustment for the lights. There is nothing visible that is before that. The adjustment isn't under the teeth, the teeth are the adjustment.

 

i highlighted the part i was talking about, i know what the green arrow is, but if you pop that cap off there is another gear...

 

I just went out and looked at it on my car. I don't think it's an adjustment of any kind. It looks like it's a cover to an opening in the headlight housing. I don't really see a reference to it anywhere in the service manual in the section dealing with the headlights.

 

if you pop that cap off there is a gear there, i think its for the left to right... but im not sure i was just wondering if anyone has played it

 

I still must be looking at the wrong thing. The plastic cap I see would be next to impossible to remove in it's normal mounted position. I'll try to look tomorrow when the sun's up but you're probably right, there must be some L/R adjustment for it.

 

if you use a flat hear screw driver, and push on that little tab towards the rear of the car it will pop off, exposing a gear

 

Just turn it and see what it does. If nothing happens, keep turning it until something does happen. Then let us know what it does.

 

lmao i did mess with it just a second ago, its the left to right i believe.. didnt have a flat wall to work with... gargage door isnt level with ground... so it looked like it was moving at an angle