Installing clear side markers
#1
Registered User
Thread Starter
iTrader: (2)
Join Date: Aug 2004
Location: Marysville, WA
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Installing clear side markers
Since the "search" functions isn't working for me, I have a question to ask. I bought a set of clear side markers for my 04 350Z and would like to know if these can be installed without removing the bumper and all that crap?
Thanks in advance.
Thanks in advance.
#2
Registered User
iTrader: (9)
Join Date: Aug 2004
Location: New York
Posts: 599
Likes: 0
Received 0 Likes
on
0 Posts
Ya, just jack up the car, put some jack stand on both sides. Then remove the bottom skid plate as if you were changing the oil. You will be able to access the side markers from the bottom. little tight in there but alot faster than removing the bumper...
#3
Just did it last night I found that on the right hand side ( passenger ) is obstructed with the window washer tank was in the way. Just remove the front right tire and take out part of the passenger side bumper so you can pull the bumper far enough away from the car to make the job go a little easier.
#5
Registered User
iTrader: (2)
Join Date: Jul 2005
Location: Portland
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
1+
I did this last week and worked fine with front bumper and tires still on. Just had to buy a small "Z" shaped screw driver from AutoZone for $5.
Originally Posted by vantage350z
Ya, just jack up the car, put some jack stand on both sides. Then remove the bottom skid plate as if you were changing the oil. You will be able to access the side markers from the bottom. little tight in there but alot faster than removing the bumper...
Thread
Thread Starter
Forum
Replies
Last Post