help: water from HID install
#1
Registered User
Thread Starter
Join Date: Jun 2009
Location: houston
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
help: water from HID install
I installed some HID headlights on my car. I had to cut a big hole in the back cap of the headlights so the wire will go though. Now water is getting in the lights. Anyone knows if there anything I can buy to close the hole up? I used silicone but it didn't work. Thanks for any help guys.
#2
Registered User
iTrader: (3)
Join Date: Feb 2008
Location: Boise, Idaho
Posts: 1,274
Likes: 0
Received 0 Likes
on
0 Posts
Try to find some rubber grommet off ebay maybe? Do you still have the wheel well plastic liner installed? That helps keep a lot of water out.
BTW have a pic of the light output? How is your cutoff? Are you using stock 03-05 base halogen housings with HID kit?
BTW have a pic of the light output? How is your cutoff? Are you using stock 03-05 base halogen housings with HID kit?
#4
Registered User
iTrader: (3)
Join Date: Feb 2008
Location: Boise, Idaho
Posts: 1,274
Likes: 0
Received 0 Likes
on
0 Posts
Good luck, you may want to drain the water out before you continue. It can condense and fog up reducing light output.
Can you show us some light output pictures on a wall, like this:
Can you show us some light output pictures on a wall, like this:
#5
Registered User
Thread Starter
Join Date: Jun 2009
Location: houston
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
there only mist in there. if anyone on here installed a DDM HID Kit on a base Z can you please tell me what u did?
Last edited by SHOCKWAVE77; 02-10-2010 at 06:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post