does anyone have any special tricks, I can't seem to make it past the 90degree bend into the body...perhaps a coat hanger isn't the best tool, but it's all I have at the moment.
I have to run +- for my component speakers and +- for LED door handles.

Thanks ahead of time

 

They actually make a tool designed to thread wire through tight bends. The problem I always had with a coat hanger was that it tended to get caught on things. The Tool I ended up getting is made of nylon and both bends much easier, and is smoother which lets it slide through wiring holes much easier. I tried digging the tool out of my toolbox... but it's buried too deep under stuff.

 

string and a shop vac?

 

Mine has a connector where the harness meets the body... this is getting aggravating

 

relocate pins and drill out the molex (connector)

 

Yea...did that today...luckily one of my best friends is an installer at the local stereo shop...we did some trading and he did it for me...all while I was sleeping in on my day off...YAYEAH!!!

 

ha... cheater!

 

anytime I can get a leg up