Picture of my steering wheel controls
06-27-2004 | 05:00 PM
#1
Picture of my steering wheel controls
Here is a picture of my steering wheel, with the Infiniti FX controls.
I use the mode button, for my GReddy overtake boost.
Got to keep things clean
Can't wait to put it to use on a worthy opponent
Props go out to my man SKiDaZZLe, in getting this to work for me!
I use the mode button, for my GReddy overtake boost.
Got to keep things clean
Can't wait to put it to use on a worthy opponent
Props go out to my man SKiDaZZLe, in getting this to work for me!
06-27-2004 | 05:14 PM
#2
How much and where did you get the part? I'd like to use it with my n2o setup. Is this something the guys over @ performance nissan could get?
Last edited by ZU L8R; 06-27-2004 at 05:23 PM.
Trending Topics
06-28-2004 | 07:41 AM
#8
Charter Member #34
Joined: May 2002
Posts: 1,228
Likes: 0
From: -
its the FX (infinti) steering wheel controls...
the cruise controls are not used, as there is an extra button (radar) on the FX, so you re-use the stock Z switch (but you still need the silver piece from the FX to match the other side)...
the audio controls have been modified to operate the greddy remote switch setup. by using the FX switch and the stock spiral connector in the steering wheel shaft, there is no need for the ugly button piece which straps to the steering wheel.
since my cruise no longer works in my car, i am going to use the cruise switch to control my remote boost switcher. just need to put a 4K ohm resistor on the cruise wires heading to the ECU to keep it happy
m
the cruise controls are not used, as there is an extra button (radar) on the FX, so you re-use the stock Z switch (but you still need the silver piece from the FX to match the other side)...
the audio controls have been modified to operate the greddy remote switch setup. by using the FX switch and the stock spiral connector in the steering wheel shaft, there is no need for the ugly button piece which straps to the steering wheel.
since my cruise no longer works in my car, i am going to use the cruise switch to control my remote boost switcher. just need to put a 4K ohm resistor on the cruise wires heading to the ECU to keep it happy
m
07-01-2004 | 04:32 AM
#11
Originally posted by ZU L8R
How much and where did you get the part? I'd like to use it with my n2o setup. Is this something the guys over @ performance nissan could get?
How much and where did you get the part? I'd like to use it with my n2o setup. Is this something the guys over @ performance nissan could get?
Just call Infiniti and ask for the steeringwheel controls from the FX.
Thread
Thread Starter
Forum
Replies
Last Post