VDC Light, SLIP, and Check Engine Light Problem
#1
Registered User
Thread Starter
VDC Light, SLIP, and Check Engine Light Problem
I was changing my O2 sensor and once everything was said and done I turned on my car and the check engine light came on along with VDC and SLIP light and it wasn’t letting accelerate above 3k rpms. I put the old one back in and it’s still the same I don’t know what I did wrong. I need help asap
#2
The car is basically going into limp mode because of an issue. You need to back-track what you did/ took apart, and make sure everything is installed correctly. Such as the plugs on all of the sensors, if you had to remove any.
Try to disconnect the battery for an hour or so, and then see if the issue persists. Also, it would help to read the codes if any from the CEL.
Try to disconnect the battery for an hour or so, and then see if the issue persists. Also, it would help to read the codes if any from the CEL.
#3
Master
iTrader: (8)
I was changing my O2 sensor and once everything was said and done I turned on my car and the check engine light came on along with VDC and SLIP light and it wasn’t letting accelerate above 3k rpms. I put the old one back in and it’s still the same I don’t know what I did wrong. I need help asap
#4
Registered User
Thread Starter
The car is basically going into limp mode because of an issue. You need to back-track what you did/ took apart, and make sure everything is installed correctly. Such as the plugs on all of the sensors, if you had to remove any.
Try to disconnect the battery for an hour or so, and then see if the issue persists. Also, it would help to read the codes if any from the CEL.
Try to disconnect the battery for an hour or so, and then see if the issue persists. Also, it would help to read the codes if any from the CEL.
Thread
Thread Starter
Forum
Replies
Last Post
eliopulos_2jz
Maintenance & Repair
8
07-25-2014 05:05 AM
ccchaorule
Brakes & Suspension
12
08-16-2012 12:12 PM
Brando222
Maintenance & Repair
3
10-24-2005 10:23 AM