UTEC Knock
#41
Banned
Thread Starter
iTrader: (1)
Join Date: Feb 2004
Location: Dayton, OH
Posts: 2,128
Likes: 0
Received 0 Likes
on
0 Posts
When you log back in to the UTEC is it in logging mode? When I connect directly to it through hyperterminal AFTER I am playing with the MPS software the UTEC is in logging mode. Maybe for some reason its not sending the command or something, I don't know. You may also be able to contact the autor of the software though the site for more specific technical support. I only know what I know from using it!
How do you connect to the UTEC currently? You say you had to try several com ports? It should be the same com port you use in Hyperterminal, unless you are using USB, then you will obviously need a serial cable (may be your problem if you are trying it all through USB, I am using a straight through RS232 cable). Good luck!
How do you connect to the UTEC currently? You say you had to try several com ports? It should be the same com port you use in Hyperterminal, unless you are using USB, then you will obviously need a serial cable (may be your problem if you are trying it all through USB, I am using a straight through RS232 cable). Good luck!
#42
Sponsor
builtZmotors
builtZmotors
iTrader: (21)
Join Date: Jul 2004
Location: Albuquerque, NM
Posts: 2,780
Likes: 0
Received 0 Likes
on
0 Posts
i connect to the utec with a usb to serial adaptor...
i'll keep playing with it
Thanks
TODD
i'll keep playing with it
Thanks
TODD
Originally Posted by KPierson
When you log back in to the UTEC is it in logging mode? When I connect directly to it through hyperterminal AFTER I am playing with the MPS software the UTEC is in logging mode. Maybe for some reason its not sending the command or something, I don't know. You may also be able to contact the autor of the software though the site for more specific technical support. I only know what I know from using it!
How do you connect to the UTEC currently? You say you had to try several com ports? It should be the same com port you use in Hyperterminal, unless you are using USB, then you will obviously need a serial cable (may be your problem if you are trying it all through USB, I am using a straight through RS232 cable). Good luck!
How do you connect to the UTEC currently? You say you had to try several com ports? It should be the same com port you use in Hyperterminal, unless you are using USB, then you will obviously need a serial cable (may be your problem if you are trying it all through USB, I am using a straight through RS232 cable). Good luck!
Thread
Thread Starter
Forum
Replies
Last Post