Vortech Installation
#42
Registered User
iTrader: (14)
Join Date: Dec 2007
Location: Middletown, DE
Posts: 603
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Hmmm .. probably 2000 miles or so since November. No mechanical issues other than the far left idler pulley on the bracket went bad and I had to replace it (bearing froze).
Almost forgot, take a look at the wiring harness running behind the blower in my pic. That's a bad spot to have that, you'll need to relocate it to the other side of the bracket it sits next to (the air box bracket). If you don't the cog pulley will rip it to shreds - fortunately I noticed it before I started the car
Almost forgot, take a look at the wiring harness running behind the blower in my pic. That's a bad spot to have that, you'll need to relocate it to the other side of the bracket it sits next to (the air box bracket). If you don't the cog pulley will rip it to shreds - fortunately I noticed it before I started the car
![Smilie](https://my350z.com/forum/images/smilies/smile.gif)
#44
Registered User
iTrader: (14)
Join Date: Dec 2007
Location: Middletown, DE
Posts: 603
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Yeah, the black harness that comes up over the wheel well and behind the blower in my pic. You should move it to the other side of the bracket it is sitting next to on the front of the wheel well.
#49
Registered User
iTrader: (15)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
well i got it all together and let it sit and idle for a while no leaks anywhere, but service engine light is on, so i have to figure that out tomorrow, have some stuff to do so had to quit for the day, but sits and idles and sounds great...any ideas on the engine light? what maf housing is supposed to be in my 03 z 22680 ca000 i beleive it is right...cause i had to get one and thats what it is and the sensor looked good when i put it in and like i said it runs fine...well guess its hard to tell till i diagnose it... till tomorrow
#51
Registered User
iTrader: (15)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
all set was p102 code or somethin for the maf sensor, and maf housing was leaking a little cause the gasket was off a little, so i got it all set and i cleaned sensor while it was out put it back in and cleared the code and its all set now...ill put up some pics later..thanks for everything guys
#57
Registered User
iTrader: (15)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
thanks for all the advice...yeah like i said the car won't be leaving the garage anytime soon, so i have been checking things over daily and letting it run and retightening the belt and what not...sucks its winter and i am not gonna drive it for at least a month...then ill be headed to function tuned....
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
10-29-2020 07:44 PM