My Vortech 2.87 setup & dyno numbers =)
07-19-2009, 05:49 PM
#161
yes, it is different.
thats what I think!.. I sent some pix to my dad to take a look at it... he also thinks thats once the bearings got destroyed it, it must of hurt the seal too and then the seal went bad after the bearing. Im going to send an e-mail to todd and superchargerrebuilds.com and see what he thinks.
If anything ill get another seal which is only 35$... I just gotta find a place to find a bearing... $135+ shipping.. is a lott of a bearing. I think. idk
thats what I think!.. I sent some pix to my dad to take a look at it... he also thinks thats once the bearings got destroyed it, it must of hurt the seal too and then the seal went bad after the bearing. Im going to send an e-mail to todd and superchargerrebuilds.com and see what he thinks.
If anything ill get another seal which is only 35$... I just gotta find a place to find a bearing... $135+ shipping.. is a lott of a bearing. I think. idk
07-19-2009, 06:31 PM
#162
New Member
iTrader: (8)
Join Date: Jan 2007
Location: terre haute, IN; STL, MO
Posts: 6,457
Likes: 0
Received 7 Likes
on
6 Posts
135? i thought those kits weren't much more than 135? if that's the case then i would buy the whole kit and just do all of it for piece of mind. I remember the ceramic kit was like 500 i think but the kit below was only like 300
07-19-2009, 06:44 PM
#163
Vendor - Former Vendor
Thread Starter
iTrader: (17)
Join Date: Feb 2007
Location: Westchester NY
Posts: 1,569
Likes: 0
Received 0 Likes
on
0 Posts
$135 is not the kit.. its just the small input shaft bearing... Iam waiting for a reply back from NACHI. I know someone on here got all the bearings for $200. $135 is a lot, im just trying to see if I can find them else where.. If not, yeah i guess your right I gotta spend another $135
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
10-29-2020 07:44 PM
CFAUVEL
Exterior & Interior
3
10-01-2015 03:20 PM
