not bad..good to see someone else getting some good power out of a vortech although built motor for that????? id be putting a t-trim on and go big boost on that if i were u with a built motor..

what kind of dyno was this on..sorry if it said it, i didnt watch the vid yet...now get to a track and see what its really got

 

eeek...i just watched the vid..whats the exhaust setup...not feelin that, but again nice numbers and should be fun if u can get past the sound

 

Exhaust sounds better in real. Not a big fan of loud exhausts, draws too much attention here.

I'm happy with power level (for now ). Though I'm considering a blower upgrade or one of those GTM TT kits

My setup is meant for circuit driving. Been racing on track for more than 3yrs.



What was the wheel/tire setup u ran for the strip?

 

oh yeah... was performed on a dynojet

 

another congrats on a different forum

you're saying you went with low compression because of our crappy fuel.. couldn't you go with higher compression and run meth all the time? because the pistons i'm ordering are 11:1 cr.

 

It comes down to tunning bro... I went low coz of our crappy fuel + I wanted a setup that could help future plans

11:1 on an FI is not an easy setup, hope it works fine with u.. and thanks again

 

^^^u wouldnt want to run meth all the time, not good to do

 

Meth is set to operate above 5psi. It's not on all the time

So, what's ur wheel/tire combo u ran at the drag strip?

 

yeah thats cool..i thought he was saying like all the time..

i had 17's with MT ET streets on the rear..DOT street tire and my normal 19's on the front

 

wow!! that's one sick 60ft and an impressive time for a 3.12 pulley. Never seen anyone run that fast using that setup, must be one hella of a driver... thumbs up bro