I'm not a fan of using the T fitting off the oil pressure sending unit port for my oil supply line for my supercharger. I have looked at a few sandwich plates and from research on here it seems like most are geared towards using them when installing an oil cooler (and sandwich plate vortech didn't bring up anything). I have seen a few that seem to have an additional port that is close to the size of the line for my oil supply line to my supercharger. Any Vortech guys out there that have gone this route? What oil filter sandwich plate did you get? Any adaptors needed to hook this plate up to the oil supply line for the Vortech? Thanks in advance

 

That's actually how my setup is...I originally had the stock T fitting but when I had my last engine build my shop just decided to feed off one of my oil sandwiches (currently using 1 Greddy Oil snadwich for the Vortech oil feed and oil temp sensor, and a mocal sandwich for my oil cooler)...so far so good...

I don't know which adapters they used though, but it should be straightfoward...maybe I'll take a pic after my next oil change...

 

the plates just have a 1/8npt.

so you just need a 1/8 npt to -4AN fitting. then a -4an fitting to go on the supercharger.

 

Thanks!