Headgasket
Jan 26, 2015 | 11:24 AM
Thread Starter
Joined: Dec 2012
Posts: 2,589
Likes: 354
From: Pan Handle
Headgasket
I know people say get oem HR headgasket for the DE, but I'm boring it out .020 over, and I think you cant use a 95.55MM head gasket with a 96 MM bore but I could be wrong. Sorry for the newb question!
Jan 26, 2015 | 01:35 PM
Jan 26, 2015 | 02:07 PM
Joined: Oct 2011
Posts: 157
Likes: 1
From: Kapolei, Hawaii
HKS and Cosworth have proven themselves for years on the forums. Pick your preference.
Jan 26, 2015 | 03:14 PM
Thread Starter
Joined: Dec 2012
Posts: 2,589
Likes: 354
From: Pan Handle
Do I get 97mm, 96.5mm, 96mm???
Jan 27, 2015 | 05:37 AM
Joined: Jul 2005
Posts: 6,474
Likes: 65
From: Chapel Hill, NC
Dynosty has their own made - get from them and they will tell you the correct size. All the same price afaik.
Jan 27, 2015 | 12:11 PM
Joined: Dec 2009
Posts: 723
Likes: 59
From: Gilbert, AZ
I’m using a standard HR head gasket on my DE w/96mm Wiseco pistons
Jan 27, 2015 | 02:59 PM
Thread Starter
Joined: Dec 2012
Posts: 2,589
Likes: 354
From: Pan Handle
So its possible to use 95.5 mm hg on 96mm block.
Jan 28, 2015 | 05:55 AM
Joined: Dec 2009
Posts: 723
Likes: 59
From: Gilbert, AZ
Yup, an OEM HR head gasket will be fine; I just put 10k miles on my built motor.
Jan 28, 2015 | 10:38 AM
Joined: Oct 2007
Posts: 8,807
Likes: 7
From: raleigh-wood NC
i would not use a HG smaller diameter than your bore, when the properly sized gaskets are available. I have a 96.5 bore and run the HKS 97mm gasket
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
VashZ350
Forced Induction
20
Oct 15, 2006 05:10 AM
phunk
Forced Induction
14
Jun 28, 2006 05:14 PM
phunk
Forced Induction
28
Jan 30, 2006 10:12 PM
phunk
Forced Induction
47
May 1, 2005 04:26 PM
Headgasket
