Does anyone have the measurements of the inside diameter of the OEM air tube hose? I'm trying to figure out what measurements I need for the hook-up of the Pi-thon air filter induction locks that connect to the JWT popcharger & for the air induction locks that connect on both ends of the OEM intake tube? Thanks. ps...do I need single ring air induction locks or double ring? What's the difference of the two?

 

These are approximate as I am using a tape measure.
I measured the inside diameter of the stock tube (the oem tube comes with the flexible connector already attached – part of the intake tube) is 3 inches inside diameter.

The ID diameter of the single ring air induction lock fully closed (compressed) is 3 5/16 or 3.3125 inches - the single ring air induction lock ID fully open is 3.5 inches and when the lock is fully closed the lock is 1 inch thick/wide.

Hope this helps I am thinking you need the single ring, but you might ask " Mapleleaf" at: http://www.zeetoyz.com/index1.htm to be sure!

Major

 

Major...Your the man! I appreciate it!