...,,..

 

nicely done! looks awesome! pretty soon u gonna replace the cats too

 

probably not, just the y-pipe. I don't want to have any possible problems with emissions.

 

Any way you can record some sound clips?

Looks great!

 

yea y-pipe will make it louder and meaner. don't worry hfc will help u pass smogs.....plus ur in texas, i don't think the laws in ur state is as **** as our **** state

 

NM ... I just found a good one:

http://crawfordz.com/videos/adamzrun_final.wmv

 

Sorry, I don't have that technology...

 

Ha!

 

Looking good!

 

VO,

Looks great andi'm pretty sure it sounds great too...but where is the Z markings on the exhaust?

 

The "Z" logo was only placed on the 1st edition Fujitsubo Ti...After the 1st edition, all the other mufflers have that writing that's in the pic

 

Valentino,

Looks fantastic. I hope you were able to clean up that WD 40 overspray I saw in one of the pic's b4 you put that sweet TI system on <smurk>

 

I did. I coated the inside of the rubber hangers only. Everything else I cleaned up with some old rags and Simpler Green. BTW I don't know if anyone noticed, but the silicone I place around the bumper clips was not part of the exhaust install. I placed silicone there to keep the rear bumper from rattling. I have a custom spare tire box that uses the trunk bottom as part of the enclosure. This cause vibration from the bumper. I little silicone rectified this.