Fujita 07 dual intake install finished..some small tips
#23
Registered User
iTrader: (23)
Join Date: Aug 2007
Location: SP, Maryland
Posts: 2,249
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by jgregory124
man i love how that sounds, I want to see stillen and aem dynos sheets before I buy 1 or 2 horse power and Ill go with the cheaper one I wish they would release the aem
#24
Registered User
iTrader: (1)
Join Date: Dec 2007
Location: Texas
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
just installed the fujita on my '08. the install was not without hitches, but its on and it sounds great. if installing this intake, there is no need in removing the sway bar. just remove the engine cover and you will gain all the clearance you need. the hardest part was getting the OEM air intakes off. i was about to give up and remove the bumper or cut them off with the reciprocating saw, when found a post that they will come off. so i twisted on them and that did the trick....just turn them clockwise and you find a point where they will slide out.
all in all, i am happy with the fujitas. they definately make a difference in sound -vs- stock. and i think they look pretty good, except for the fact that the MAF's are on top instead of side or bottom. jury is still out on performace gains.
all in all, i am happy with the fujitas. they definately make a difference in sound -vs- stock. and i think they look pretty good, except for the fact that the MAF's are on top instead of side or bottom. jury is still out on performace gains.
Thread
Thread Starter
Forum
Replies
Last Post