So I got this http://www.z1motorsports.com/350_g35/product_info.php?products_id=5833 will it work?

 

Question I get a low input knock sensor an multiple miss fire codes every now an then. It comes stays for a day or two but than its gone for a while. But the car almost always runs horribly. If the knock sensor was bad wouldn't the light stay? An if it was the knock sensor wouldn't it just run poorly when the cell was on?

 

Yes all you need is that harness, z1 now sells it separately which is great because you don't have to buy the whole injection harness for it. And no it will not make the SEL light stay on but when you check it it'll always be there.

 

Thanks !

 

OK knock sensor an harness are replaced code gone running better. Started her back up with out fully connecting the coupler to the tb. Dumb I know lol but know I have two code cruise control sensor an throttle position sensor . Prob from not connecting the coupler.. but my car stinks like gas now tho? Any ideas?

 

Anyone?

 

Reconnect everything, Make sure there's no air leaks then reset your ECU .

 

Bringing this back from the dead real quick. my 04 with 119k threw the P0327 (low input knock sensor yada yada) and a P0302 (cylinder 2 misfire).

I just want to clarify..for the knock sensor code, I do NOT need to replace the knock sensor, just the harness, right? Looks like thats what I'm reading in a few places

 

Hi guys

I want to do the job on my car,

I need the Knock sensor and harness for 350Z 2003 non rev up VQ35DE engine

I have been looking online and there seems so many different versions of them, could you tell me the best to go for? a particular brand?

any links appreciated

Thanks

 

https://www.z1motorsports.com/engine...c-4_35_98.html

 

Will a knock sensor problem cause a 350z to not start?

 

I really don't know but I would not think it would.
Really all I can say is ckeck everything...battery, fuses, cables ect.
Hope it helps. And good luck.