hi all

i was wondering how could i flush engine oil cooler (oil)? i have setrab oilcooler from gtm oilcooler kit.

 

I would just change your oil then add new oil turn on the car run it for a few mins get the rpms up a lil then change the oil again and repeat till you are satisfied

 

Remove oil cooler unless you can disconnect the hoses and have plenty to play with.

One end will be held high, with oil poured into it. Use a funnel.

Other end will go into a drain pan. Use an open one like you'd use for an oil change so you can see when the fresh oil is starting to flow through.

 

I have the GTM oil cooler as well, just detach the lines and drain. Unless you have it mounted upside down.