nachospizza

iTrader: (1)

Hi guys I am interested getting this Greddy Intelligent Informeter but I see there are two to choose! One is smaller screen one and the other is bigger screen one! Could you tell me the difference between the two and also which one can show me my Z error codes and also reset those codes? Thank you very much!

nachospizza

iTrader: (1)

Sorry here are the photos of the two!!!

AdvanZ33

iTrader: (105)

The one on the right is the older version. If I remember correctly, it just monitors; doesn't reset codes. I got bored with it pretty quick.

350z006

iTrader: (79)

+1...I currently use one for data monitoring off the ECU; I don't think they sell the small screen one anymore, and I don't see why you would want it anyway...

And yes you cannot erase CEL codes with the Informeter, either of them...different CAN BUS interface maybe

nachospizza

iTrader: (1)

Ok Thank you very much I guess I shouldn't get one then : )

nachospizza

iTrader: (1)

I am wondering if I can upgrade the software inside this Informeter? Also it gets really hot is it normal?

350z006

iTrader: (79)

Yes you can; I had mine upgraded at Greddy USA...

nachospizza

iTrader: (1)

I was playing with the informeter and I don't know how to do the DTC to check for error code! I read the manual and it said I can do scan or clear those codes. But all I have is the DTC Number 0 that's it no scan or clear I can choose??? Did I setup something wrong??? Here are photos I took from my Informeter...

350z006

iTrader: (79)

DTC = CEL....you cannot look at error codes with the Informeter on the 350z; I think its a different CANBUS...

nachospizza

iTrader: (1)

So the Informeter will not show me which error codes I have is that right? So DTC = CEl and means it only show me how many error codes I have but not the code numbers are???