crsracing19

So in the process of a wire tuck and I would like to cut maybe 3 wires to the ignition coils to help untangle the spaghetti mess. I know the wires are rf sensitive, and I'm not looking to change the length of them just cut and resolder/ shrink wrap them properly.

Is this safe to do or would this affect, performance, or the harness negativity, even if soldering and shrink wrapped properly,??

dkmura

iTrader: (64)

I would never advise anyone to cut into any part of their engine or main harness. Particularly for cosmetic reasons, there's simply too many things that can go wrong.

djamps

iTrader: (1)

If done properly you should be fine... just make sure everything is soldered WELL and heat shrunk.