96.5 11.0.1 88MM BC Crank NA build
#83
Registered User
iTrader: (23)
I thought I saw in another thread several guys told you the block needed to be clearances for that crank......At any rate a little research would tell you that because I have seen several thread mention it. So I would call that a self inflicted delay.
Anyway hopefully it goes smooth from here on out, and youre up and running in no time.
Anyway hopefully it goes smooth from here on out, and youre up and running in no time.
Last edited by Sylvan Lake V35; 06-03-2011 at 03:53 PM.
#87
Registered User
iTrader: (4)
Join Date: Aug 2010
Location: SC
Posts: 365
Likes: 0
Received 0 Likes
on
0 Posts
i ended up getting oem washers, but i have a correct set of thrust washers if anyone is interested in some.
on another note, sucks for the delay. but how did you manage to bend 2 bearings?
and on another another note, my heads are FINALLY done and going to the machine shop to get resurfaced tomorrow so i can get them assembled. anyone know what kinda piston/valve clearance i will have with the cp 11:1 pistons, BC 264 cams and stock valves? lol
on another note, sucks for the delay. but how did you manage to bend 2 bearings?
and on another another note, my heads are FINALLY done and going to the machine shop to get resurfaced tomorrow so i can get them assembled. anyone know what kinda piston/valve clearance i will have with the cp 11:1 pistons, BC 264 cams and stock valves? lol
#99
Registered User
iTrader: (4)
Join Date: Aug 2010
Location: SC
Posts: 365
Likes: 0
Received 0 Likes
on
0 Posts
sureeeeeee
well i was hopin to have mine all buttoned up saturday but when i bolted the rear timing cover up and was about to put the bank2 cam sprockets/chain on...i noticed the tensioner guide was cracked so i ordered all new tensioners yesterday.....should be here tomorrow, but i did bolt up the qx4 coolant pipe deal lol. so itll be all buttoned up soon
keep the updates comin bro
well i was hopin to have mine all buttoned up saturday but when i bolted the rear timing cover up and was about to put the bank2 cam sprockets/chain on...i noticed the tensioner guide was cracked so i ordered all new tensioners yesterday.....should be here tomorrow, but i did bolt up the qx4 coolant pipe deal lol. so itll be all buttoned up soon
keep the updates comin bro