Can anyone recommend a shop or person in the South end (Puyallup,Tacoma, Auburn, Kent) to roll my rear fenders? Thanks

 

carnutz is the cheapest ive found in bellvue, $60 a fender. or $100 if you want to cut them instead get a little more room

 

Go to Ray @ Garage Autohero. He might be a bit far for you though, he is close to Eric's house.

 

Thanks guys, I'll look into both.

 

+1. Just got mine done there.

 

anyone got a contact number for garage hero?

googled them and all i got was a myspace page.

i guess they pretty good? whats their prices?

 

I think it is best to Email Ray. fourdoor510@yahoo.com. Eric has his # I think.

 

Nobody knows of a shop around the Tacoma area that can roll/cut fenders? I went to a bunch of body shops today and its like they are scared to do it. A couple places said guaranteed that the paint will chip if they are rolled, and all of them said the fenders couldn't be cut blah blah blah... I forget their reasoning... I mean if I have to go all the up to Bellvue area I'll do it. Its just hard to get time off work and its easier if I can get it done locally.

What type of tool would be best in your guy's opinion to cut fenders? I'm wondering if I had the right kind of tool I could do it myself.

 

sawzall

 

A few of us G35 drivers got our fenders rolled at Intec Racing in Kent, hit them up, they do a great job.

 

I got my fenders roll by Ray. I just tried a phonebook pull but didnt use a thick enough phone book. Might try again or just add more camber.

 

If you're in the Southern area, try Drift Office?

 

Intec Racing charges $80/hr, they usually can get both the rears done in one hour. They don't do invasive body work like cutting and putting, but they can roll them all the way up to flat

 

i got mine for 50 bucks a corner at illtech in downtown tacoma. they did a pretty good job.