My 2jz swap
#2
New Member
Thread Starter
The gte vvti
2j with the new bw369sxe turbo
Thw greddy intake welded to the stock runners with a custom 12 injector setup for staged injectors
The maverick motorsports jz/vq twin plate clutch
Testfitting the motor
Test fitting with mainfold and turbo
Welding up the mounts
2j with the new bw369sxe turbo
Thw greddy intake welded to the stock runners with a custom 12 injector setup for staged injectors
The maverick motorsports jz/vq twin plate clutch
Testfitting the motor
Test fitting with mainfold and turbo
Welding up the mounts
Last edited by chase z; 07-25-2017 at 03:48 PM.
#3
New Member
Thread Starter
Bc vvti 272 cams.
The mounts done and mounted just have to paint them
Welded on the wastegate flange
The mounts done and mounted just have to paint them
Welded on the wastegate flange
Last edited by chase z; 07-25-2017 at 03:48 PM.
Trending Topics
#11
New Member
Thread Starter
Makeing som templates to make the fuel cell that will go in the oem battery location
The huge fuel pump and pre filter
My shitty aluminum welds.
Testfitting the cell
Checking for leaks . It hold just a tad over 3 gallons.
And this is the cell for the large injectors 2200cc that will only be on during boost and they will be using e85
The huge fuel pump and pre filter
My shitty aluminum welds.
Testfitting the cell
Checking for leaks . It hold just a tad over 3 gallons.
And this is the cell for the large injectors 2200cc that will only be on during boost and they will be using e85
#12
New Member
Thread Starter
Monting the ac condenser to the radiator
All was going good tell this happened. I was drilling the bracket and by backing piece of aluminum slipped and i puched a hole through 2 of the cores. Sucks.
So i cut off the bad portion and welded up the core. So with the extra room there i will make a oil catch can in that space.
I had to cut up the rad support to make toom but it all fits tight now
Heres the cut up rad support
All was going good tell this happened. I was drilling the bracket and by backing piece of aluminum slipped and i puched a hole through 2 of the cores. Sucks.
So i cut off the bad portion and welded up the core. So with the extra room there i will make a oil catch can in that space.
I had to cut up the rad support to make toom but it all fits tight now
Heres the cut up rad support
The following users liked this post:
KingBaby (10-02-2017)
#15
New Member
Thread Starter
Yea I don't blame u man lots of people post about doing things in the car world with out the means or patience to get it done. Other then the wiring harness everthing on this car will be done by me.
The following users liked this post:
travlee (08-08-2017)
#18
New Member
Thread Starter
I got a plug and play harness allready.