EMERGENCEY tool stuck in frame
#1
EMERGENCEY tool stuck in frame
Hey gents. not sure what to do about this one. Only have 5 days to get the car ready for track weekend and this is a show stopper. Long story short. Brother in law used the tool backwards when i walked away to deal with the baby. How do i get this out?
#2
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
I would bet a 2x2 piece of wood and a 10 pound sledge
#4
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Damage will be minimal if any,wood Drift and pound it out
Trending Topics
#8
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Waiting for an update, hope it went well
#9
Lol, I was literally digging into my pocket for my phone to do just that, then I got your reply. It was a success! I beat that b***ch into submission. It took about an hour and a new 4 lbs hammer. Had to file and send quite a bit. Left a nasty gouge. But the new bushing was installed in under 90 secs I think. Never wanna do this job ever again. Oh and the Z1 tool. Almost totally destroyed. Thank you so much for the inputs!!
Taken by pointing towards the rear. Note the gouge at the top
Taken facing towards the front of car
Taken by pointing towards the rear. Note the gouge at the top
Taken facing towards the front of car
The following users liked this post:
yosip1115 (06-26-2018)
#13
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Glad it worked out, and get a bigger hammer. 10 pound deadblow beats out some amazing results
Thread
Thread Starter
Forum
Replies
Last Post
GNZ67
Maintenance & Repair
0
03-24-2016 07:49 PM