FS: [FT] custom 3" single exhaust
Thread Starter
Registered User
iTrader: (16)
Joined: May 2010
Posts: 3,011
Likes: 1
From: Deep in Michigan
[FT] custom 3" single exhaust
i have a 3" custom exhaust routed to passenger side bumper exit.
i have central 20 rear bumper with this custom exhaust. However, i haven't tried it on stock bumper so i'm not 100% sure how it'll fit under the bumper exhaust hole.
It does have the welded Apexi exhaust control valve. Also has vibrant resonator. This is Y-pipe back exhaust.
The bottom of the resonator has been flattened out due to my car being low. Also the top of the resonator is close to the driveshaft. (Probably have the top of the resonator squeezed in little, or get it fixed at a muffler shop) (it doesnt touch it though)
This is where i mounted the control valve.
Videos:
The only reason i'm wanting to trade is because it's too loud for me. Well, of course single straight pipe is going to be loud.
The work has been done at GarageLife in ElMonte.
$180..........
i have central 20 rear bumper with this custom exhaust. However, i haven't tried it on stock bumper so i'm not 100% sure how it'll fit under the bumper exhaust hole.
It does have the welded Apexi exhaust control valve. Also has vibrant resonator. This is Y-pipe back exhaust.
The bottom of the resonator has been flattened out due to my car being low. Also the top of the resonator is close to the driveshaft. (Probably have the top of the resonator squeezed in little, or get it fixed at a muffler shop) (it doesnt touch it though)
This is where i mounted the control valve.
Videos:
The only reason i'm wanting to trade is because it's too loud for me. Well, of course single straight pipe is going to be loud.
The work has been done at GarageLife in ElMonte.
$180..........
Last edited by JDMStanced; Apr 10, 2013 at 07:34 PM.